PRODUCT DESCRIPTION     

Crystal Weather Saver is an acrylic emulsion paint specially formulated for exterior walls. It is extremely durable against harsh weather and adheres well to all types of exterior wall surfaces. Crystal Weather Saver break through formula provides tough resistance against dirt, algae, fungus, flaking and alkali.

    SURFACE PREPARATION     

Bare Masonry Surfaces

Bare masonry surfaces should be completely dry and free from dust, dirt and grease. Use a bleach solution to treat the surface affected by fungus or algae Repair cracks, uneven surface with Crystal Wall Putty or any suitable filler. Smoothern the putty / filler areas with sandpaper and dust off thoroughly. Allow all surfaces to dry completely prior to painting. Avoid painting when the moisture content and alkalinity of the walls is still high.

Previously Painted Surfaces
Remove unstable paint film and loose chalk by rubbing down using abrasive paper or wire brust and dust off. Use Crystal Wall Putty to repair cracks if necessary. Prime with Crystal Wall Putty Wall Sealer.

    APPLICATION DATA     

Drying Time             :Touch Dry: 15 minutes.
                                (Dependent on temperature and humidity)
                                Hard Dry:45-60 minutes.
Recoating Interval  :2-3 hours.

Theoretical Coverage :15 - 17m2 per liter per coat.
(Many vary depending on the substrate conditions)
No. of Coats :3 - 4
For Optimum Results :Apply 1 Coat of Crystal wall Seater before applying
Crystal Plastic Emulsion
Refer to Technical Data Sheet for application and thining procesture.

    DIRECTIONS FOR USE     

.Stir well before use.
.Application can be done by brush, roller or spary.
.Thin (by volume) up to 50-70% with clean water for brush application,
 20-30% & for roller application & 30-40% for air spray application.
.Clean up all equipment with water immediately after use.

    SAFETY, HEALTH & ENVIRONMENTL INFORMATION     

.Keep out of the reach of children and away from food and drink, Do not
 swallow the paint. If swallowed, seek medical advice immediately.
.Ensure good ventilation during application and drying.
.Do not breathe in vapor or sanding dust. Avoid contact with eyes and skin
 When applying paint, it is advisable to wear eye protection. In case of 
 Contact with eyes, rinse immediately with plently of water and seek medical
 advice
.Wear protective clothing and mask white applying paint. Use soop and
 water to clean the splashes from skin.
.Paint must always be stored in a cool and dry place.
.Care must be taken during transportation. Always keep container in a 
 secure upright position.
.Use sand to contain any spillage. Dispose off paint in accordance with the 
 appropriate environmental Quality Regulation.
.Do not discharge into drains or envirnment.
.Does not contain any added Lead, Mercury, Chromium and Codmium
 compunds.
.Chemical Safety Data Sheet available on request.